Introduction of the use of pillow packing machine

The pillow packing machine is very famous in our life. Because people use it in many aspects. While do you know how to use it?
pillow packaging machine

The pillow packing machine is very famous in our life. Because people use it in many aspects. While do you know how to use it?

pillow packaging machine
pillow packaging machine

Security Check

Generally, make sure that there is no debris on the conveyor belt, the work panel, the horizontal sealing knife seat. And no one else is operating the pillow packing machine.

Turn on the switches

Firstly, turn on the main power switch, then turn on the temperature control switch of the temperature control meter. And check the temperature display of each temperature control meter. The heating temperature changes due to changes in the packaging film material, packaging speed, and indoor ambient temperature.

Set the bag length

Set the length of the packaging bag according to the length of the distance between the two color marks on the packing film.

Install and adjust

Install the packaging film to make it run smoothly, and adjust the meshing center of the horizontal sealing knife holder and the linear speed of the horizontal sealing knife holder.

Adjust the packaging speed to the lowest (about 35 bags/min), start the adjustment, adjust the front and rear positions of the bag former and the symmetry of the left and right wings, adjust the engagement height of the horizontal sealing knife seat to align with the horizontal center height of the packaged product, and adjust The linear speed of the horizontal sealing knife holder (referred to as “knife speed”) is roughly the same as the linear speed of the packaging film, that is, no paper accumulation and no pulling of paper, so that the packaging film can run smoothly.

Pillow packing machine
Pillow packing machine

Adjustment of material level

In short, put the product to be packaged on the pillow packing machine. And adjust the material level to make it correct.

Carry out a trial run

After booting up, appropriately speed up the packaging speed and observe whether the adjustment results of the above steps are normal. Besides, if it is not normal, continue to adjust the first steps; if it is normal, set the packaging speed to an appropriate value and check whether the packaging appearance and sealing meet the requirements ( After the speed increases, the heater temperature should increase accordingly).

Enter normal production

Finally, after you adjustment all the above properly, you can begin your production with the pillow packing machine.